StudyVault
Home Unit Overview Revision Techniques Previous Lesson Next Lesson

Back to Home

Page tint:
0:00 / 0:00

Coastal Processes and What Controls Them

A Coast Is Never Still

UK coasts look solid, but they change every day. Two groups of processes work on them at once. From above, rain, frost and gravity attack the cliff face. From below, the sea erodes the rock, carries the broken pieces away and drops them somewhere else. Almost all of the sea’s energy comes from waves. Waves are made by wind blowing over the water. The bigger the fetch, the stronger the wind and the longer it blows, the more energy a wave carries when it reaches the shore.

Not all waves behave the same way. Destructive waves are tall, steep and frequent. Their backwash (the water running back down the beach) is stronger than their swash (the water rushing up it), so they drag material out to sea. Constructive waves are low and gentle. Their swash is stronger than their backwash, so they push material up the beach and build it up.

Weathering and Mass Movement

Weathering weakens cliffs before the sea ever touches them. In freeze-thaw weathering, rainwater seeps into cracks, freezes and expands, then thaws. Repeated many times, this splits pieces off the rock. In chemical weathering, rainwater is slightly acidic and slowly dissolves rocks such as chalk and limestone. In biological weathering, plant roots grow into cracks and burrowing animals loosen the rock.

Weathered rock is then pulled downhill by gravity. This is called mass movement. In a rockfall, pieces of hard rock break off a steep cliff and drop to the beach. In a slump, soft rock such as clay becomes soaked with rain, grows heavy and slips down along a curved surface. In a slide, a block of rock moves down a straight slope, often along a layer in the rock. The fallen material piles up at the cliff foot, where waves can then attack it.

Key Fact

Coasts are shaped by processes from the land (weathering and mass movement) as well as from the sea. Weathering weakens the cliff; mass movement delivers loose rock to the beach; waves then erode and remove it.

Marine Erosion: Four Processes

When waves reach the coast, they wear away rock in four different ways. You need to be able to name and define each one.

  • Hydraulic action — the sheer force of waves hitting the cliff. Water forces air into cracks and squeezes it. When the wave pulls back, the air expands suddenly, and over time this breaks the rock apart.
  • Abrasion — waves throw sand and pebbles at the cliff. These scrape and grind the rock like sandpaper.
  • Attrition — rocks carried by the sea knock against each other. They break into smaller, smoother and rounder pieces.
  • Solution — slightly acidic seawater dissolves certain rocks, especially chalk and limestone.
Key Fact

The four marine erosion processes are hydraulic action, abrasion, attrition and solution. Destructive waves in storms make all four work harder.

Transport: Moving the Load

The material the sea carries is called its load. How it moves depends on its size and on how much energy the water has.

  • Traction — large boulders are rolled along the seabed.
  • Saltation — pebbles bounce along the seabed in a series of hops.
  • Suspension — fine sand and silt are carried along within the water, which makes it look cloudy.
  • Solution — dissolved minerals are carried invisibly in the water. Notice that ‘solution’ is both an erosion process and a transport process.

Material also travels along the coast. In the UK the prevailing wind usually blows from the south-west, so waves often arrive at an angle. The swash carries sediment up the beach at that angle. The backwash then pulls it straight back down the slope under gravity. Repeated thousands of times, this zig-zag carries sand and shingle along the shore. The process is called longshore drift.

When waves lose energy, they drop their load. This is deposition. It happens in sheltered bays, where the coastline changes direction, or when constructive waves dominate in calm weather.

Step one: the prevailing wind drives waves towards the beach at an angle. Step two: the swash carries a pebble up the beach in the same direction as the wind. Step three: the backwash pulls the pebble straight back down, at right angles to the coast, because gravity acts downhill. Step four: the next wave picks it up again. The pebble ends up a little further along the beach each time. Attrition along the way means pebbles often get smaller and rounder in the direction of drift — something you can measure on fieldwork, although real beaches do not always show a perfect pattern.

What Controls the Rate of Change?

Geology. Rock type is the biggest reason why some coasts retreat quickly and others hardly change. Hard, resistant rocks such as granite, and to a lesser degree chalk, erode slowly and form steep cliffs. Soft rocks such as clay and sand erode quickly and slump easily.

The structure of the rock matters too. Joints, faults and cracks are weak points that hydraulic action and freeze-thaw can attack. A hard rock with many cracks may erode faster than you would expect. The Holderness coast in East Yorkshire is made of soft boulder clay and is one of the fastest-eroding coastlines in Europe, losing on average about 2 metres a year, with some places losing much more in a single storm. By contrast, the chalk at Old Harry Rocks in Dorset has stood up to the sea long enough to form stacks.

Key Fact

Soft rocks such as boulder clay erode far faster than resistant rocks such as chalk or granite. Cracks and joints are weak points that speed up erosion even in hard rock.

Seasonal weather. UK winters bring more frequent low-pressure storms, stronger winds and more rain. This means more destructive waves, more freeze-thaw and more saturated, slumping cliffs. Beaches often lose sand in winter. In calmer summers, constructive waves tend to rebuild them.

Extreme events. A single severe storm can do more damage than years of normal weather. Storm surges — where low air pressure and strong winds raise the sea level — let powerful waves reach the top of beaches and attack cliffs that are normally out of reach. Most coastal erosion happens on just a few stormy days each year.

Slowing processes down. Structures such as groynes trap sediment moving by longshore drift. The wider beach absorbs wave energy and protects the cliff behind it.

Speeding processes up. The sediment trapped by groynes no longer reaches beaches further along the coast. Those beaches become narrower, so cliffs there erode faster. Building on cliff tops adds weight and extra drainage water, which makes slumping more likely. Removing sand or shingle from beaches also leaves cliffs less protected.

Key Fact

The rate of coastal change depends on geology, seasonal weather, extreme events and human activity working together. Weak rock plus winter storms produces the fastest retreat.

Every coastal landform you study next is built from these processes. Erosion, transport and deposition do the work; rock type, weather and people decide how fast it happens.

Exam question

AI feedback
This is a guide, not an exam mark. If your teacher marks it differently, go with your teacher.

Next lesson Back to unit
Explainer